Eurotech VoIP2 AII Series Manual de usuario descargar pdf (Pagina 42)

2009

EUROTECH USER MANUAL

VoIP

All™ Series: 4 Channel Gateway User Manual 42

4. Mark in the check boxes the ports to call.

5. Check the 'Active' check box.

6. Press the 'Save' button.

The call can come from any port cellular or VoIP.

When the calling number is in the range of numbers, the gateway will direct the call to the port

that is marked for this range.

If there are few ports marked, the gateway will rotate the calls between the ports.

If there are no available ports, the gateway will decline the call and you will hear a busy tone.

Directing calls by the calling IP Address

1. In the 'Ports Control', select the routing mode to be 'By IP'.

2. Select empty row in the Ports control table. Press the 'Add Row' if there is no empty row in

the table.

3. Enter in the 'Start' and 'Stop' boxes the range of IP addresses to route.

4. Mark in the check boxes the ports to route the calls.

5. Check the 'Active' check box.

6. Press the 'Save' button.

When a VoIP call comes from IP address in this range of IP's, the gateway will direct the call to

the port that is marked for this range.

If there are few ports marked, the gateway will rotate the calls between the ports.

If there are no available ports, the gateway will decline the call and you will hear a busy tone.

*Note: When the 'Source Routing' is enabled, all the settings in the prefixes window are

irrelevant.

Chapter 6.5.2.4: Call Monitor

To View the active VoIP calls.

Fig: The Call Monitor window.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 63 64

Sin comentarios

Eurotech VoIP2 AII Series Manual de usuario Pagina 42