EUROTECH USER MANUAL
VoIP
2
All™ Series: 4 Channel Gateway User Manual 41
2. Enter in the 'Connection Time' the maximum time in seconds the network message will
commence.
3. Enter in the 'Number of detection' the amount of consecutive network messages detections
before the SIM will be blocked.
4. Press 'Save'.
Now, when a call will be connected below the 'Connection Time' the gateway will detect that
this is a network message, and it will disconnect the call so you will not hear the message from
the network. After a number of consecutive calls detected as in the amount of 'Number of
detection' the SIM will be blocked.
Chapter 6.5.2.2: Test Call
Test Call is a mechanism to randomly generate calls from the cellular ports to predefined
destinations. This mechanism can be used to test incoming calls to the cellular ports.
Select the ‘Test Call’ tab. To setup the 'Test Call' do the following:
1. Select the ports to calls from by checking the check box.
2. Enter in the 'Calls Nums', the list of numbers to call from the selected ports.
3. In the 'Call Timers', define the parameters for the calls:
·
Length of Calls – The minimum and maximum length of the calls, a call will last a
random amount of seconds within this range.
·
Frequency of Calls – The minimum and maximum length of times between the calls,
the time between calls will be a random amount of seconds in this range.
·
Start Time – The time to start the calls.
·
End Time – The time to stop the calls.
4. Press the Active button to start the 'Test Calls'.
5. When you want to end the 'Test Calls' press the 'Stop' button.
Chapter 6.5.2.3: Source Routing
Directing calls according to their calling number or their IP address.
When the ‘Source Routing’ is enabled the calls will be directed according to the source of the
calls (the calling number or the IP address the call came from), rather than the destination of the
calls (the prefix of the dialed number).
There are two modes of directing the calls:
·
By Number - The calls will be directed by the calling number.
·
By IP – The calls will be directed by the IP address the call came from.
Open the ‘Source Routing’ tab.
Directing calls by the calling number
1. In the 'Ports Control', select the routing mode to be 'By Number'.
2. Select empty row in the Ports control table. Press the 'Add Row' if there is no empty row in
the table.
3. Enter in the 'Start' and 'Stop' boxes the range of number to route.
(30 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales