Eurotech VoIP2 AII Series Manual de usuario descargar pdf (Pagina 26)

2009

EUROTECH USER MANUAL

VoIP

All™ Series: 4 Channel Gateway User Manual 26

Chapter 4.4: SIP Servers

In the window below, the user may control the SIP Server settings. Press the ‘SIP’ tab to access

the window below:

4.4.1 Internal SIP Server Settings

• 'Codec Priority' - Define ‘Codec 1' – 'Codec 4', the priority of the Codec that the SIP

Server will use when connecting VoIP calls. The codec that will be used is first one from

the list, that both of the VoIP phone can work with.

• 'SIP Port' – Is the TCP port of the SIP Server.

• 'RTP Start Port' – Is the first port of the range of ports of the SIP RTP ports. Usually the

ranges of ports that the SIP uses are from 5060 to 5100.

• 'RFC2833 Payload Type' – Is the type of payload to be used by the SIP.

• ‘Authentication’ – When enabled requires a password to register the VoIP

ALL internal

SIP Server.

• ‘Realm’ – Is the name of the SIP Server realm of operation.

4.4.2 Hosts - Connecting the VoIP

ALL to an External IP PBX

To call from the Gateway to IP PBX or any SIP Server, you need to connect the Gateway to the IP

PBX SIP Server. There are two ways to connect to the external SIP: registering the Gateway in

the external SIP, or working without registration.

4.4.2.1 Registering the Gateway in external SIP Server

You can connect the VoIP

ALL’s internal SIP Server to an external SIP Server by adding a host in

the ‘Hosts’ table. When the SIP Servers are connected you will be able to make calls from the

Gateway to the Host SIP.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 63 64

Sin comentarios

Eurotech VoIP2 AII Series Manual de usuario Pagina 26