Eurotech VoIP2 AII Series Manual de usuario descargar pdf (Pagina 25)

2009

EUROTECH USER MANUAL

VoIP

All™ Series: 4 Channel Gateway User Manual 25

4.2.3 Dialing from the IP PBX

When calling from an IP PBX to cellular via the gateway. The number of the mobile phone needs

to be sent in the INVITE message of the SIP.

To set up the dialing from the IP PBX to a cellular mobile phone through the gateway:

• Dial from the PBX to the gateway.

• View the 'Monitor' of the gateway - check the number that the gateway dialed (i.e.

(39)0545555555).

• Go to the prefix table of this port.

• Setup the prefix of this port (i.e. 39).

• Setup the 'Remove Prefix' to the number of digits You wish to remove (2 digits)

• Dial from the PBX the number 390545555555.

• The call will now be routed through this port to the mobile phone by removing the

prefix (39) and calling the desired cellular number 0545555555

Chapter 4.3: Tone Levels

In the window below, the user may set the tone for each port. Rx is the tone of the speaker and

Tx is the tone of the microphone. Press the Tone tab to see:

Adjusting the Levels

1. Click the blank area on the right side of the tone bar, in the grey blank area, a slider will

appear. Adjust the slider to the desired level (From -30dbm to +30dbm).

2. Repeat this action for all the tones you wish to adjust.

3. Press Save to activate and save all changes.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 63 64

Sin comentarios

Eurotech VoIP2 AII Series Manual de usuario Pagina 25