Eurotech VoIP2 AII Series Manual de usuario Pagina 39

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 64
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 38
2009
EUROTECH USER MANUAL
VoIP
2
All Series: 4 Channel Gateway User Manual 39
CLIR – Show or Hide the number of the SIM.
Net ID – Locking the SIM on a specific network.
BCCH Locking the SIM on a specific BCCH. When empty it will lock on the best
reception BCCH.
BCCH rssi – The minimum reception for rotation.
BCCH Timer This function rotates the BCCH. The rotation is preformed according to
the BCCH Timer, measured in seconds, between all BCCH, which have better
reception than the BCCH rssi.
The local SIM parameters for Call Duration mode:
Current Balance – The total amount of units for the SIM. It should be set always higher
then 0.
Primary Bill Interval – The interval of time (in seconds) for the beginning of the call.
Primary Interval Count – The number of times the Primary Bill Interval will repeat.
Primary Cost per Bill Int The amount of units the Primary Bill Interval will count for.
Secondary Bill Interval The intervals of time (in seconds) after the end 'Primary Bill
Interval'.
Secondary Cost per Bill Int – The amount of units the Secondary Bill Interval will count
for.
Min Call – the minimum amount of calls per connection.
Max Call – the maximum amount of calls per connection.
'Call Count' – Shows the amount of calls this SIM made last time he was connected.
'Call failed' – Shows the amount of consecutive failed calls this SIM made last time he was
connected.
Chapter 6.5: General Settings
Select ‘General’ from the top of the ports list on the left side of the window.
Here you can set up all the settings that affect all of the ports and setup the advanced features.
Chapter 6.5.1: General Settings tab
General Parameters
‘Default SIM’- Define when the local SIM will work:
·
'By Default' – The Local SIM will work on insertion.
·
'By Time Table' – The local SIM will work only when set in the time table.
‘SIM Load Type’- In call duration mode, this parameter will define the order of the operation of
the SIMs that is in the list that you have set for the day.
Vista de pagina 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 63 64

Comentarios a estos manuales

Sin comentarios