Eurotech ED-C3 02 Especificaciones descargar pdf (Pagina 41)

BIOS Setup

DPD5MAN101

8.2.4. Peripheral Configuration

Table 8. Peripheral Configuration Setting

Setting

Contents

Spread Spectrum Clock

Enable Spread Spectrum Clock.

・Disabled(Default) - disable

・Enabled - enable

8.2.5. HDD Configuration

Table 9. HDD Configuration Setting

Setting

Contents

SATA Device

Set SATA device.

・Disabled - disable

・Enabled(Default) - enable

Interface Combination

*13

Set operating mode of SATA controller.

・IDE

・AHCI(Default)

・RAID

Serial ATA port X

*13

Show Device ID connected to Port X. When device is not

connected, a message “Not Install” is displayed.

Hot Plug

*13

Enable hot plug.

Note: Hardware support required

・Disabled(Default) - disable

・Enabled – enable

External Port

*13

Set port as internal or external.

・Disabled(Default) - disable

・Enabled - enable

Port Topology

*13

Set connection mode of SATA 6Gb/s port. Only port 0and port

1 support SATA 6Gb/s.

・DirectConnect

・CableUp(Default)

SATA Device Type

*13

Solid State Drive should be selected only when SSD is

connected to SATA port.

・Hard Disk Drive (Default)

・Solid State Drive

*13: possible to set by changing SATA Device to “Enable”

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 57 58

Comentarios a estos manuales

Sin comentarios

Eurotech ED-C3 02 Especificaciones Pagina 41

Comentarios a estos manuales